Extremely Precise Alloy Density Calculation is Difficult
Folks, Ken writes: Dr. Ron, Thanks for your helpful post. I get close (-1.1%) with your formulas for an alloy I am working with. I think the crystal...
Folks, Ken writes: Dr. Ron, Thanks for your helpful post. I get close (-1.1%) with your formulas for an alloy I am working with. I think the crystal...
Wandering through the references to indium metal on the internet, I sometimes see it referred to as, “that ‘rare’ metal.“...
I will be participating in a webinar hosted by the good people at www.SocialMediaToday.com which features Shel Holtz,Rob...
I should take a minute a publicly thank our solar tabbing ribbon engineers for doing an excellent job today. We needed 6 different tabbing ribbon...
Folks, After a bit of a break, the adventures of Patty, Rob, and The Professor continue: The plane droned on as it made its slow march from Detroit to...
The week before Mothers Day…an excellent time to talk about bonding! Indium metal really shines when it comes to bonding a wide variety of...
Okay, I admit it, I was sneaky and grabbed a photo of Tommy Acchione during his presentation of “Measuring the Performance of Low Melting Point ...
It is critical for your B2B Marcom materials to align with the performance and capabilities of your products and services - as well as with the e...
The Society of Vacuum Coaters 2010 technical conference took place last week, so this week I’ve been rounding up the display sputtering tar...
Folks, I think the analysis is a little off in a recent posting by Dominique Numakura Re the cost of a product like the iPad. Numakura states: Co...