Package-on-Package (PoP) Solder Paste
A quick trip to discuss roadmapping with one of the world’s top processor manufacturers, and a visit to discuss Pb-free power die-attach materia...
A quick trip to discuss roadmapping with one of the world’s top processor manufacturers, and a visit to discuss Pb-free power die-attach materia...
The “wave soldering flux deactivation temperature question” arises every few weeks, and the easy answer is that wave solder fluxes are des...
This week a customer in Asia asked why one of our new epoxy fluxes was not allowing the package-on-package (PoP) device to be picked up from the dippi...
I just received a customer inquiry regarding a phenomenon that is little studied and even less quantified; “How many times can I reflow a s...
Folks, Before the mid 2000s, electronics manufacturers had to be concerned with the challenges of innovation at a low cost. Failure to meet the...
Tombstoning, simply, is the wetting of one side of a component before the other side, which causes the setting forces of the solder to lift the compon...
Folks, Patty had been working with engineering on a new product that needed a very precise and controlled volume of the stencil printed “brick&...
Jon major recently joined the Indium Corporation as a Product Manager for Solar back-end assembly products. I greeted him with this impromptu int...
Since I couldn’t find a good beginners guide to c-Si metallization paste, (not even......
Folks, Let’s assume you are trying to improve the productivity of your SMT assembly lines. You work at a facility that manufactures high v...
You’re reading this because you want to know more about LTTF-6363 low temperature metallization paste right? Perfect. p style="margi...
Folks, The conclusion of the Bob and Fred break saga…... Phil stared, “The uptime on AXI’s four SMT production lines is…...